Roland VersaUV LEF2-200 Service Notes page 145

Service mode
I/S MENU
WIPER AGING
I/S MENU
CARTRIDGE
IC status
It reads the information written on the IC of each carriage.Following messages are displayed when errors are found.
Ink cartridge is not inserted
SLOT1
NO CARTRIDGE
System error due to the damage of driver IC placed on INK TANK BOARD
SLOT1
NOW PROCESSING..
Remove all cartridges before pressing ENTER
CARTRIDGE
IC CHECK
IC check
IC CHECK
Next, IC communication is checked individually by SLOT. When a cartridge is inserted, it automatically starts to communicate with
the cartridge IC and checks it. Display shows [OK], when the communication is done properly.As cartridge is removed, the next
cartridge SLOT number to be inserted is displayed. Starting from SLOT1, it
continues to SLOT6 in order. When checking SLOT6 is completed, the following message is displayed.
IC CHECK
IC CHECK
SLOT1
*Any cartridge can be used for this check as long as it has IC chip on it.
*No information is written on IC chip during this check.(Normally, the count of the cartridge installation is
written. However, the count of the installation in this check is not written.)
*Before this IC check, make sure cartridge sensor is working properly.
CARTRIDGE
SLOT 1
CARTRIDGE
SLOT 2
CARTRIDGE
SLOT 6
SYSTEM ERROR
Normal
WIPER AGING
COMPLETED
Error (beeps 2 times)
WIPER AGING
FAILED !!
Set cartridge to SLOT1
IC CHECK
SLOT1 INSERT
Error
IC CHECK
SLOT1 ERROR
Normal
IC CHECK
SLOT1 OK
From SLOT1 to 6 in order
Set cartridge to SLOT6
IC CHECK
SLOT6 INSERT
Error
IC CHECK
SLOT6 ERROR
Normal
IC CHECK
SLOT6 OK
IC CHECK
COMPLETED
All cartridges must be removed before entering IC CHECK menu. It detects ink cartridge
IC, writes and loads information, and checks the communication. First of all, it con rms
if there is the driver for IC detection. The left display indicates that error is found
SYSTEM ERROR
on driver.
It returns to IC CHECK menu by pressing ENTER key.When communication is failed,
COMPLETED
it displays as below.
It returns to IC CHECK menu by pressing ENTER key.
ERROR
SL1 : SERIAL
Serial No. of the ink cartridge IC is displayed.
1402A30C010000A5
SL1 : INK TYPE
Ink type of the ink cartridge IC is displayed.
EUV K
SL1 : CAPACITY
Ink capacity of the ink cartridge IC is displayed.
200cc
SL1 : LOT NO.
Lot No. of the Ink cartridge IC is displayed.
40216A
SL1 : CONSUM.
100.000cc Ink consumption of the ink cartridge is displayed.
SL1 : TIME
0y000d00h00m00s The used time of the ink cartridge is displayed.
SL1 : INSERT
The insert count of the ink cartridge is displayed
1 times
SL1 : FLAG
The ag information of the ink cartridge is displayed.
000000000
A cartridge with no IC is inserted, wire breakage or short circuit
SLOT1
NO IC CHIP
Data error
SLOT1
DATA ERROR
2-4
2
L EF 2-200