Roland VersaUV LEF2-200 Service Notes page 187

Belt Tension Adjustment
2.
Loosen two screws located at the left end of the belt halfway round .
C AUTION
Be careful with the sharp edges around the belt when loosening the screws .
Top view (left end of the belt)
3.
Insert a wrench through the holes on the side frame prepared for the adjustment, and loosen the two screws to make a
gap of 3 mm between the tip of the screw and the idle pulley holder . (The belt tension cannot be adjusted higher when
the screw contacts the idle pulley holder .)
NOTE
The gap between the screws and the idle pulley can be seen from both the front and rear side of the machine .
1 . Idle pulley holder
4.
Turn the screw to adjust the value of the tension gauge to be within the proper value .
* Turn the screw clockwise: Tension is increased
* Turn the screw counterclockwise: Tension is decreased
3mm
1
2-46
2
L EF 2-200