Encoder Scale Replacement
2.
Remove the spring plate from the encoder scale and attach it to the encoder scale where there is no black dot written on
it .
1
C AUTION
Make sure not to make scratches or put grease on the encoder scale when attaching it . Do not touch the surface of the
encoder scale .
3.
Put the encoder scale in between the encoder plate and the guide rail .
C AUTION
• Do not loosen or fasten the screws that secure the encoder plate .
• The encoder scale is covered with protective film . Peel it off carefully .
4.
Attach the right end with the plate and hook up the spring on the left end . Make sure that the encoder scale fits in place .
5.
Move the print-head carriage across the whole width of the machine manually and confirm that the encoder scale does
not make contact with the encoder sensor . Also, check that the encoder scale is in between the slit of the encoder sensor .
6.
Perform Chapter 2 "Linear Encoder Setup" .
2
2
1
3
1 . Spring plate
2 . Black dot
1 . Encoder scale
2 . Encoder plate
3 . Guide rail
1-100
1
L EF 2-200