Roland VersaUV LEF2-200 Service Notes page 215

Print Head Height Adjustment
C AUTION
When tightening the two screws on the front, be careful not to tighten them too hard . Doing so may cause the carriage
cover to be distorted and the print heads may become shifted .
Workflow
C AUTION
• To prevent hardened ink from entering into the nozzle, refresh print head before the adjustment . Perform medium
cleaning on all print heads if 20 minutes passes .
FUNCTION
CLEANING
MEDIUM CL.
• Always use the UV protection sheet during this adjustment, or ink will harden and clog inside the ink line .
• This adjustment is required when the table unit is replaced . This adjustment is NOT required when you remove the table
unit and attach the same one . This is to adjust the print head height parallel to the table unit . This adjustment is NOT
required when the print head is replaced .
FUNCTION
CLEANING
MEDIUM CL.
AB
2-74
2
L EF 2-200