Multitech CommPlete CC2400 System Installation And Quick Start Manual page 93

25. As the system restarts, type your User ID and password at the prompts,
pressing ENTER after each item. The system detects the installed
devices and the MultiCommManager Environment Setup menu
reappears:
MultiCommManager Environment Setup
1. System Defaults Setup
2. Device Specific Setup (Required)
Enter Selection
26. Type 2 and press E
NTER
CommPlete. The options that are most important to set are the IP
addresses for the controller and the IP addresses for each RAS. If these
are not properly set, you will be unable to remotely configure the
CommPlete.
Device Specific Setup
1. Controller Setup (Required)
2. Ras Setup
3. T1 Setup (Required)
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection
27. Type 1 and E to configure the controller. A screen appears that
NTER
shows the controller's current settings and the IP Address option:
IP Address (-(previous), q(uit), <0.0.0.0>):
1. IP Address
2. Date
3. Time
4. Default Trap IP
5. Default Gateway
6. Subnet Mask
7. Read Community :********
8. Write Community
Enter Selection
The controller's IP Address must not be the same address as the Default
Trap IP or the Default Gateway IP address.
28. Verify the settings for each option. To change a value, type the number
corresponding to the menu option. If no changes are needed, or all
necessary changes have been made, type d and ENTER. Proceed to
MR9600 Controller Setup step # 47.
29. Type 1 and ENTER to change the Controller's IP Address. Type the new
address and ENTER.
30. From the setup menu, type 2 and ENTER to change the current Date.
Enter the date in the format: <month>/<day>/<year>, and press ENTER
to return to the setup menu.
31. Type 3 and ENTER to change the current Time. Use either 12-hour or
24-hour format, and press ENTER. The setup menu reappears.
32. Type 4 and ENTER to change the Default Trap IP. Enter the IP address
that the controller will send traps to without requiring the IP to be
2 Configuration Quick Start
(q(uit), <1>): 2
to set up the individual devices in the
(-(previous), q(uit), <3>):
:192.168.4.150
:10/4/2000
:10:24am
:0.0.0.0
:0.0.0.0
:0.0.0.0
:********
(-(previous), q(uit), d(one), <1>):
1
1
93