Multitech CommPlete CC2400 System Installation And Quick Start Manual page 100

System Installation and Quick Start Guide
54. Type y and press E
55. To configure another RASCard, type the device number of the RASCard
PRI Card(s) Setup
Note: Before you begin the configuration procedures, please verify that all T1
cables and/or PRI cables are connected to their respective telco lines. For
information on telco line setup, contact you telco.
Note: as you configure the PRI Card(s), make note of your settings on the
Site Information sheet.
56. If you do not need to configure any PRI interfaces, type q, press E
100
Start 2nd Exclusion:0.0.0.0
End 2nd Exclusion:0.0.0.0
Administrator Password:********
Protocol:RADIUS
Primary Server:192.168.90.1
Secondary Server:0.0.0.0
Shared Secret Password:********
Config Ras? (<y>, n):
NTER
appear:
Configuring ...
Config Completed
The RAS must be reset to finish the config.
(<y>, n): y
Type y to reset the RASCards. The Device Specific Setup menu
reappears:
Select a RAS Card (2A, (-(previous), <d>(one).
Note: Look for error messages such as "Timeout Waiting for Responses"
or Not Enough IP Addresses." If errors are encountered, refer to the
FAQ and Troubleshooting section of your documentation set.
you want to set up, and repeat steps 41–56. Otherwise, type d and press
E to finish. The following message appears:
NTER
Device Specific Setup
1. Controller Setup
2. Ras Setup
3. T1 Setup (Required)
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection (-(previous), q(uit), <4>):
and go to step 68. Otherwise, type 5 and press E
PRI interfaces. The following option appears:
Select a PRI Card (2A, -(previous), <d>(one)):
Type the device number of the PRI card you want to configure, or press
to configure the currently selected
E
NTER
Settings from menu appears:
to save your changes. The following messages
NTER
PRI card. The Use
Reset the RAS?
,
NTER
to configure the
2A