Table of Contents
Advertisement
10. Turn on the PS9600 power supplies. The power supply indicators should
light and the controller indicators should flash during the power-on self-
test.
11. Connect one end of the provided E1 cable(s) to the E1 jack(s) on the
RASCard, and the other end to an E1 wall jack.
Note: Do not connect the E1 line(s) until you are ready to proceed with
the configuration procedures
12. Turn on each RASCard. The indicator in the power switch and front
panel should light.
Installation of the CommPlete Communications Server hardware is complete. Your
next step is to configure the controller, RASCard, and E1 interface(s) so they can
communicate with the outside world. Please turn to Chapter 2.
1 System Installation
15
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the CommPlete CC2400 and is the answer not in the manual?
Questions and answers