Multitech CommPlete CC2400 System Installation And Quick Start Manual page 59

49. Type y and press E
RASCard Setup
50. Verify that all RASCards are turned on. Type 2 and press E
51. Valid device numbers are listed in the option line. Type the device
52. Type 1 or press ENTER if you want to use or modify the settings stored
NTER
changes. If you answer y, it will not affect any current connections. The
following screen appears:
IP Address 192.168.4.182 stored
Trap IP Address 192.168.4.150 stored
Gateway IP Address 192.168.4.1 stored
Subnet mask 255.255.255.0 stored
Read Community public stored
Write Community public stored
Device Specific Setup
1. Controller Setup
2. Ras Setup
3. T1 Setup (Required)
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection (-(previous), q(uit), <2>):
Note: as you configure the RASCard, make note of your settings on the
E1 Site Information sheet.
your RASCards. The following line appears:
Select a Ras Card (1A, 5A, 9A, 13A, -(previous), <d>(one)):
5A
number of the RASCard you want to set up and press E
Settings from menu appears:
1. Use Active Settings (pre-configured card)
2. Use System Defaults (new card)
Enter Selection (q(uit), <1>:
in the currently selected RASCard. Type 2 if you want to use or modify
the default RAS settings. A screen similar to the following appears, with
the options displayed varying based on the Address Method selected:
Getting Ras Info ......
1. IP Address
2. Subnet Mask
3. Default Gateway
4. Primary DNS Server
5. Backup DNS Server
6. Frame Type
7. Address Method
8. Address Pool Start
9. Address Pool End
s t
10.Start 1 Exclusion
st
11.End 1 Exclusion
n d
12.Start 2 Exclusion
nd
13.End 2 Exclusion
14.RAS Express Password :**********
15.Protocol
16.Primary Server
17.Secondary Server
2 Configuration Quick Start
to save your changes. Type n to cancel your
:0.0.0.0
:255.255.255.0
:192.168.4.1
:0.0.0.0
:0.0.0.0
:TYPE_II
:Address pool
:192.168.4.200
:192.168.247
:0.0.0.0
:0.0.0.0
:0.0.0.0
:0.0.0.0
:Local
:0.0.0.0
:0.0.0.0
2
to set up
NTER
. The Use
NTER
59