Getting Version Information - Multitech CommPlete CC2400 System Installation And Quick Start Manual

99. Click Add to create in the Explorer an IP site for the CommPlete
100. Double-click Physical View. You should see the name of the new site
101. Double-click the IP site you just created, double-click on the Group icon,
102. Select the RAS card by highlighting the RAS icon and choosing the
103. Select the Edit button to check the Read and Write Community strings
Installation is complete. If you need to change any settings, you can do so from
MultiCommManager or by using Telnet to access the CommPlete controller and
servers.

Getting Version Information

To complete the site information sheet, you should verify the installed
versions and record the information. Follow the procedures in the Verifying
Software/Firmware Version Information section at the end of this chapter.
controller and servers. Enter the IP address of the controller, a unique
long name, and a unique three-letter short name. Click OK.
next to a green "IP." If the "IP" is gray, double-check your IP settings.
Also, make sure the Read Community and Write Community settings
match how they are set on the MR9600 controller.
then double click the Rack icon. You should be able to see the modems.
appropriate slot (1A, 5A, 9A or 13A).
for the RASCard.
2 Configuration Quick Start
85