Multitech CommPlete CC2400 System Installation And Quick Start Manual page 38

System Installation and Quick Start Guide
32. Line Coding is the signaling technique of transmitting binary ones and
33. The FXS Signaling Options are protocols used to determine the status of
34. Press E
38
zeros (bits).
Type the number of the line coding that your T1 line uses, or press E
to accept the default coding. The following menu appears:
FXS Signaling Options
1. E&M Wink Start
2. E&M Immediate Start
3. Ground Start
4. Loop Start
Enter Selection (-(previous), q(uit), <1>):
the A and B signaling bit within a DS-0 (24 DS-0s make up a T1). The A
and B signaling bits determine the status of the DS-0 with regards to On
Hook, Off Hook or Ringing.
Type the number of the signaling option recommended for your T1 line,
or press E to accept the default option. The following menu appears:
NTER
Transmit Level
1. - 0.0dB
2. - 7.5dB
3. -15.0dB
4. -22.5dB
Enter Selection (-(previous), q(uit), <1>):
to leave the transmit level set at -0.0 dB unless Multi-Tech
NTER
technical support instructs otherwise. The Systems Default Setup menu
appears:
System Defaults Setup
1. Network Defaults
2. Ras Defaults
3. Ras Security Defaults
4. T1 Defaults
5. E1 Defaults
6. PRI Defaults
Enter Selection (-(previous), q(uit), <5>):
Type q to complete the set up. The Change Supervisor user ID and
Password menu appears:
Change Supervisor user ID and Password
Enter User ID:
Enter new password: ********
To prevent an unauthorized person from changing the system
configuration, type a new Supervisor ID and password.
Repeat new password: ********
Security information updated
System will now be re-booted...
The system prompts you to re-enter the password. Re-type the
password and press ENTER to store the information and re-boot.
NTER
q