Multitech CommPlete CC2400 System Installation And Quick Start Manual page 65

E1 Card(s) Setup
Note: Before you begin the configuration procedures, please verify that all E1
cables and/or PRI cables are connected to their respective telco lines. For
information on telco line setup, contact you telco.
Note: as you configure the E1 Card(s), make note of your settings on the E1
Site Information sheet.
80. If you do not need to configure any E1 interfaces, type q, press E
81. Type the device number of the E1 daughter card you want to configure,
82. The Getting E1 Card info .... screen appears:
83. Type y to save your changes, or n to cancel them. The following option
84. To configure another E1 card, type the device number of the T1 you want
and go to step 71. Otherwise, type 4 and press E
interfaces. The following option appears:
Select a T1/E1 Card (<1B>, 1C, 5B, -(previous), d(one)):
13B
or press E to configure the currently selected E1 daughter card.
NTER
The Use Active Settings from menu appears:
Use Active Settings from:
1. Use Active Settings (pre-configured card)
2. Use System Defaults (new card)
3. Use Stored Settings (swapping cards)
Enter Selection (q(uit), <1>:
Getting E1 Card info...
1. Channel Polling Interval (sec):20
2. Error Threshold
3. Disconnect Timeout (sec)
4. Framing Format
5. Line Coding
6. Signal Options
7. DNIS-digits(1-64 or )for auto :0
8. Country Selection
9. Line Buildout
Enter Selection (-(previous), q(uit), d(one), <1>: 1
Verify all values. If you need to change a value, type the option number
and ENTER. Type the new value and press ENTER.
When all changes have been completed, type d(one). The following
screen appears:
Save changes and config the device? (<y>, n):
appears:
Select a T1/E1 Card (13B, -(previous), d(one)):
to set up, and repeat steps 81-83. Otherwise, type d and press E
finish. The Device Specific Setup menu reappears:
Device Specific Setup
1. Controller Setup
2 Configuration Quick Start
to configure the T1
NTER
1
:10
:11
:CRC4
:Alternate Mark Inversion
:R2 MF
:ITU
:120 Ohm
y
d
,
NTER
to
NTER
65