Multitech CommPlete CC2400 System Installation And Quick Start Manual page 54

System Installation and Quick Start Guide
16. Type 3 and press ENTER to set up RAS Security Defaults. A screen that
17. The default RAS Express Password is blank (i.e. no password). To
18. Use the Protocol menu to specify the default security protocol for your
19. Type the IP address of your primary server and press ENTER. The
20. If you do not have a secondary server, press ENTER to accept the default
21. Type the Shared Secret Password, then retype the string to confirm that
54
2. Ras Defaults
3. Ras Security Defaults (Required)
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection (-(previous), q(uit), <3>): 3
shows the current RAS security defaults appears with the RAS Express
Password option:
RAS Express Password:********
Protocol:RADIUS
Primary Server:0.0.0.0.
Secondary Server:0.0.0.0
Shared Secret Password:********
RAS Express Password (-(previous), q(uit), <********>):
prevent unauthorized changes to your system, you should type a new
RAS Express password. When you press ENTER at the end of the string,
you are asked to type the string again to confirm that you entered it
correctly. When you press ENTER again, the following menu appears:
Protocol
1. Local
2. RADIUS
3. TACACS+
Enter Selection (-(previous), q(uit), <2>):
system. Select Local if you do not have a security server on your
network. Select RADIUS if you have a RADIUS server on your network.
Select TACACS+ if you have a TACACS+ server on your network.
When you press ENTER, the Primary Server menu appears:
Primary Server (-(previous), q(uit), <0.0.0.0>):
Secondary Server menu appears:
Secondary Server (-(previous), q(uit), <0.0.0.0>):
address of 0.0.0.0. If you are using local security (i.e., RASExpress
security rather than RADIUS or TACACs+), leave these addresses set at
the 0.0.0.0 default. When you finish the second option, press ENTER to
display the Shared Secret Password option:
Shared Secret Password (-(previous), q(uit), <********>):
you typed it correctly. Press ENTER again. The System Defaults Setup
menu reappears:
System Defaults Setup
1. Network Defaults
2. Ras Defaults
3. Ras Security Defaults
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection (-(previous), q(uit), <4>: 4