Multitech CommPlete CC2400 System Installation And Quick Start Manual page 52

System Installation and Quick Start Guide
6. Type 1 and press E
7. In the System Default Setup menu, type 1 and press ENTER to set up
8. Press ENTER to accept the default address of 0.0.0.0, ,or type the IP
9. Press ENTER to accept the default address of 0.0.0.0, or type the address
10. Press ENTER to accept the default address of 0.0.0.0 (if you do not have a
11. Press ENTER to accept the default address of 0.0.0.0 (if you do not have a
52
NTER
to the following appears:
System Defaults Setup
1. Network Defaults (Required)
2. Ras Defaults (Required)
3. Ras Security Defaults (Required)
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection (-(previous), q(uit), <1>):
The settings you create in the System Defaults Setup menu become the
default settings for any new device that is inserted into the CommPlete
chassis. In data entry lines, current settings are displayed in angle
brackets. Press Enter to accept a current setting and continue to the next
option or menu; press – (hyphen) to go back to the previous menu; or
press q to quit.
network defaults. The following screen appears:
Default Gateway:0.0.0.0
Subnet Mask:0.0.0.0
Primary DNS Server:0.0.0.0
Backup DNS Server:0.0.0.0
Default Gateway (-(previous), q(uit), <0.0.0.0>):
Press ENTER to display the Default Gateway option:
address for the default gateway (the local router, if any), for example
192.168.4.1, and press ENTER. When you press ENTER, the Subnet
Mask option appears:|
Default Gateway (-previous), q(uit), <192.168.4.1>):
Subnet Mask (-previous), q(uit), <0.0.0.0>):
mask for your network; for example 255.255.255.0 and press ENTER (for
a class C network, the mask is 255.255.255.0). When you press ENTER,
the Primary DNS Server option appears:
Default Gateway (-previous), q(uit), <192.168.4.1>):
Subnet Mask (-previous), q(uit), <0.0.0.0>):
Primary DNS Server (-previous), q(uit), <0.0.0.0>):
DNS Server) or type the address of your primary DNS server, for
example 192.168.11.251, and press ENTER. When you press ENTER, the
Backup DNS Server option appears:
Default Gateway (-previous), q(uit), <192.168.4.1>):
Subnet Mask (-previous), q(uit), <0.0.0.0>):
Primary DNS Server (-previous), q(uit), <0.0.0.0>):
Backup DNS Server (-(previous), q(uit), <0.0.0.0>):
backup DNS server) or type the address of your backup DNS server and
press ENTER. When you press ENTER, a screen similar to the following
one appears showing your network defaults and the System Defaults
Setup menu:
to configure the system defaults. A menu similar
1