Multitech CommPlete CC2400 System Installation And Quick Start Manual page 22

System Installation and Quick Start Guide
10. Connect one end of the provided T1 cable(s) to the T1 jack(s) on the
11. Turn on the RASCard. The indicator in the power switch and front panel
Installation of the CommPlete Communications Server hardware is complete. Your
next step is to configure the controller, RASCard, and T1 interface(s) so they can
communicate with the outside world. Please turn to Chapter 2.
22
RASCard, and the other end to a T1 wall jack.
Note: Do not connect the T1 line(s) until you are ready to perform the
configuration procedures.
should light.