Multitech CommPlete CC2400 System Installation And Quick Start Manual page 83

82. To change the Framing Format, type 3 and press ENTER. The Framing
Format menu appears:
Framing Format
1. 12 Frame Multiframe (F12-D3/4)
2. 4 Frame Multiframe
3. Extended Super Frame
4. 72 Frame Multiframe - Remote Switch Mode (F72)
Enter Selection
83. Framing Format is the method by which binary ones and zeros (bits) are
organized.
Type the number of the framing format that matches the PRI line and
ENTER, or press E
NTER
Info... menu reappears.
84. To change the Error Correction option, type 4 and ENTER. The Error
Correction menu appears:
Error Correction (CRC4/6)
1. Disabled
2. Enabled
Enter Selection
85. Press E to accept the current setting, or type the number of the new
NTER
option and press E
NTER
86. To change the Call Distribution option, type 5 and ENTER. The Call
Distribution menu appears:
Call Distribution
1. First Available
2. Uniform Distribution
3. One to One
Enter Selection
87. The Call Distribution options determine the method by which incoming
analog calls are distributed to modems on a PRI segment. One to One
will result in calls going to the modems according to the DS-0 that the
call comes in on. First available will result in calls going to the first
modem, starting with 3A, that is not in use. Uniform Distribution will
result in calls going to the first available modem, starting with the last
modem that was picked.
88. Verify that the distribution method that you wish to use is selected and
press E . The Getting PRI option menu appears.
NTER
89. To change the Set Carrier option, type 6 and ENTER. The Set Carrier
option appears:
Set Carrier
1. PCM24/T1
2. PCM30/CEPT
Enter Selection
2 Configuration Quick Start
(-(previous), <3>):
to accept the default option. The Getting PRI
(-(previous), <2>):
. The Getting PRI info ...menu appears.
(-(previous), <3>):
(-(previous), <1>):
83