Introduction - Multitech CommPlete CC2400 System Installation And Quick Start Manual

System Installation and Quick Start Guide

Introduction

This section describes how to get your new CommPlete Communications
Server up and running as quickly as possible. Your first step was to install
the CommPlete and connect it to power, to your LAN, and to your WAN
lines. Now, to enable them to communicate with the outside world, you
must configure the MR9600 controller, the RAS96 RASCards, and the T1/E1
daughter card or PRI/EPRI card. The following configuration procedures
require a terminal or a PC with terminal emulation connected to the
configuration port of the MR9600 controller. The procedures have been
organized based on configuration type. Proceed to the procedure
appropriate to your setup.
When you have completed the configuration of your CommPlete, complete
the Verifying Software Firmware Version Information section of this chapter.
This procedure will verify that you have the most current resources available
for you CommPlete. If you need further instructions, refer to the individual
User Guide for each component, or refer to the on-line help provided with
your software. At the end of the verification procedure, you will be
instructed to go to the following link on the Multi-Tech web site:
http://www.multitech.com/support/
Use the Product Support list box to select Commplete.
The Commplete web page provides you with a list of the latest firmware and
software revisions. In addition this site offers links to the Multi-Tech FTP
site, should you need to upgrade. Compare the list found on this web page to
the list you have assembled on your Site Planning sheet. For instructions on
upgrading a specific element, refer to the instructions provided in the
individual User Guides.
Note: If you experience any problems or questions, contact Technical
Support, Monday - Friday, 8:30AM to 5:00PM (Central Time), by calling (800)
972-2439.
30
For T1 configuration, refer to page 31.
For E1 configuration, refer to page 50.
For PRI (23B+D) configuration, refer to page 67.
For EPRI (30B+D) configuration, refer to page 87.