Multitech CommPlete CC2400 System Installation And Quick Start Manual page 73

Type the number of the line coding option that your PRI line uses, or
press E to accept the default coding. The following menu appears:
NTER
Framing Format
1. 12 Frame Multiframe (F12-D3/4)
2. 4 Frame Multiframe
3. Extended Super Frame
4. 72 Frame Multiframe - Remote Switch Mode (F72)
Enter Selection
25. Framing Format is the method by which binary ones and zeros (bits) are
organized.
Type the number of the frame format that matches that of your PRI line,
or press E to accept the default format. The following menu
NTER
appears:
Error Correction (CRC4/6)
1. Disabled
2. Enabled
Enter Selection
26. In the Error Correction menu, type 2 and press E
correction, or type 1 and press E
following menu appears:
Call Distribution
1. First Available
2. Uniform Distribution
3. One to One
Enter Selection
27. The Call Distribution options determine the method by which incoming
analog calls are distributed to modems on a PRI segment. One to One
will result in calls going to the modems according to the DS-0 that the
call comes in on. First available will result in calls going to the first
modem, starting with 3A, that is not in use. Uniform Distribution will
result in calls going to the first available modem, starting with the last
modem that was picked.
Press E to leave Call Distribution set at first available, or type in the
NTER
number of the new setting and press E
appears:
Set Carrier
1. PCM24/T1
2. PCM30/CEPT
Enter Selection
28. In the Set Carrier menu, type the number of the appropriate carrier
setting and press E
NTER
Active Channels (-(previous), q(uit), d(one) <23>):
2 Configuration Quick Start
(-(previous), q(uit), <1>):
(-(previous), q(uit), <2>):
to disable error correction. The
NTER
(-(previous), q(uit), <3>):
. The following menu
NTER
(-(previous), q(uit), <1>):
. The following screen appears:
to enable error
NTER
73