Multitech CommPlete CC2400 System Installation And Quick Start Manual page 70

System Installation and Quick Start Guide
11. Press E
12. Type 2 and press E
13. Type the number of the frame type used by your network, or press
14. Use the Address Method menu to specify how IP addresses will be
70
Backup DNS Server (-(previous), q(uit), <0.0.0.0>):
to accept the default address of 0.0.0.0 (if you do not have a
NTER
backup DNS server) or type the address for your backup DNS server and
press E . When you press E
NTER
one appears that shows your new network defaults and presents you
with the System Defaults Setup menu:
Default Gateway (-(previous), q(uit), <192.168.4.1>):
Subnet Mask (-(previous), q(uit), <255.255.255.0>):
Primary DNS Server (-(previous), q(uit), <192.168.11.251>):
Backup DNS Server (-(previous), q(uit), <0.0.0.0>):
System Defaults Setup
1. Network Defaults
2. Ras Defaults (Required)
3. Ras Security Defaults (Required)
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection (-(previous), q(uit), <2>):
NTER
appear:
Frame Type:TYPE_II
Address Method:Address Pool
Wan Port IPCP:Enabled
Frame Type
1. TYPE_II
2. SNAP
Enter Selection (-(previous), q(uit), <1>):
E to accept the default. TYPE_II is the standard Ethernet frame type.
NTER
SNAP is supported only by some older UNIX systems. When you press
E , the following menu appears:
NTER
Address Method
1. via DHCP server
2. Address pool
3. Per port config
4. RADIUS
Enter Selection (-(previous), q(uit), <2>):
allocated to the remote users. Select via DHCP server if you have a
DHCP server on your LAN. Select Address pool if the IP addresses you
assign to the clients are from a contiguous pool of addresses. Select Per
port config if you want to assign a specific address to each remote port.
Select RADIUS if you want to use your RADIUS server to assign IP
addresses. Type the number of the address allocation method you want
the RAS to use, or press E
E , the following menu appears:
NTER
, a screen similar to the following
NTER
to set up RAS defaults. The current RAS defaults
to accept the default. When you press
NTER
2