Multitech CommPlete CC2400 System Installation And Quick Start Manual page 69

Enter Selection
6. Type 1 and press E
NTER
menu appears:
System Defaults Setup
1. Network Defaults (Required)
2. Ras Defaults (Required)
3. Ras Security Defaults (Required)
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection
The settings you create in the System Defaults Setup menu become the
default settings for any new device that is inserted into the CommPlete
chassis. In data entry lines, current settings are displayed in angle
brackets. Press E
NTER
option or menu; press - (hyphen) to go back to the previous menu; or
press q to quit.
7. In the System Defaults Setup menu, type 1 and press E
network defaults. The following screen appears:
Default Gateway:0.0.0.0
Subnet Mask:0.0.0.0
Primary DNS Server:0.0.0.0
Backup DNS Server:0.0.0.0
Press ENTER to display the Default Gateway option:
Default Gateway (-(previous), q(uit), <0.0.0.0>):
8. Press E to accept the default address of 0.0.0.0, or type the IP
NTER
address for the default gateway (the local router if any), for example
192.168.4.1, and press E
option appears:
Default Gateway (-(previous), q(uit), <192.168.4.1>):
Subnet Mask (-(previous), q(uit), <0.0.0.0>):
9. Press E to accept the default address of 0.0.0.0, or type the address
NTER
mask for your network; for example 255.255.255.0, and press E
class C network, the mask is 255.255.255.0). When you press E
Primary DNS Server option appears:
Default Gateway (-(previous), q(uit), <192.168.4.1>):
Subnet Mask (-(previous), q(uit), <255.255.255.0>):
Primary DNS Server (-(previous), q(uit), <0.0.0.0>):
10. Press E to accept the default address of 0.0.0.0 (if you do not have a
NTER
DNS server) or type the address of your primary DNS server, for
example 192.168.11.251, and press E
Backup DNS Server option appears:
Default Gateway (-(previous), q(uit), <192.168.4.1>):
Subnet Mask (-(previous), q(uit), <255.255.255.0>):
Primary DNS Server (-(previous), q(uit), <192.168.11.251>):
2 Configuration Quick Start
(q(uit), <1>): 1
to configure the system defaults. The following
(-(previous), q(uit), <1>):
to accept a current setting and continue to the next
. When you press E
NTER
. When you press E
NTER
1
to set up
NTER
, the Subnet Mask
NTER
(for a
NTER
, the
NTER
, the
NTER
69