Introduction; Pre-Installation Notes - Multitech CommPlete CC2400 System Installation And Quick Start Manual

System Installation and Quick Start Guide

Introduction

This chapter describes briefly how to unpack and install the hardware
components of the CommPlete Communications Server. Full instructions for
the installation of each component can be found in its respective user guide.
The following installation procedures have been organized based on product
type and configuration. After reading the Pre-Installation Notes, you should
refer to the initial installation page for your product (page 11 for CC9600
users, and page 20 for cc2400 users) and then proceed with the procedure
that matches your setup.

Pre-Installation Notes

Warning: Interconnection directly, or by way of other apparatus, of ports
marked "SAFETY WARNING see instructions for use" with ports marked or
not so marked may produce hazardous conditions on the network. Advice
should be obtained from a competent engineer before such a connection is
made.
Note: Such apparatus may have been approved subject to limitations in its
use.
10
All installation must be done by a qualified service person.
To reduce emissions, be sure to use blanking plates to cover empty slots
in the CC9600 or CC2400 chassis.
This product is intended to be hard-wired to the network. The final
connection to the network is the responsibility of the public
telecommunications network operator or a person authorized by that
operator.
Any other apparatus, including cable and wiring, connected between the
MT5634HD8 modem and the point of connection to any speech band
circuit shall comply with the following:
1. The overall characteristics of this apparatus shall be such as to
introduce no material effect upon the electrical conditions presented
to one another by the modem and he speech band circuit.
2. The apparatus shall comprise only
a. apparatus approved for the purpose of connection between the
modem and a speech band circuit; and
b. cable and wiring complying with a code of practice for the
installation of equipment covered by this part of BS 6328 or such
other requirements as may be applicable.