Multitech CommPlete CC2400 System Installation And Quick Start Manual page 63

e. Repeat steps a through c to set up each port.
f. When each port has been set up, select d(one).
Config Port? (<y>, n):
1.Port Number
2.Port Type
3.Remote Address
Enter Selection (-(previous), q(uit), d(one), <24>: d
68. Change the RAS Express Password, by typing the option number for
RAS Express Password and ENTER. The RAS Express Password menu
appears:
RAS Express Password:********
Primary Server:0.0.0.0
Secondary Server:0.0.0.0
Shared Secret Password:********
RAS Express Password (-(previous), q(uit), <********>):
Type a new password if you want a unique administrator password for
the RASCard; otherwise, press ENTER to accept the current password.
The Getting RAS info menu appears.
69. Change the Protocol option by typing the option number for Protocol
and ENTER. The Protocol menu appears:
Protocol
1. Local
2. RADIUS
3. TACACS+
Enter Selection
Type the number of the security protocol for the RASCard, or press
E to accept the default security protocol (Local). The Getting RAS
NTER
Express info menu reappears.
70. Change the Primary Server IP address by typing the option number for
Primary Server and ENTER.
Primary Server (-(previous), q(uit), <0.0.0.0>):
71. Type the IP addresses of your primary security server, or press E
accept the defaults that you set up earlier. If you are using local security
(i.e., RASExpress security rather than RADIUS or TACACs+), leave these
addresses set at the 0.0.0.0 default. When you press Enter, the Getting
RAS Express info menu reappears:
72. Change the Secondary Server IP address by typing the Secondary Server
IP address option and ENTER.
Secondary Server (-(previous), q(uit), <0.0.0.0>):
73. Type the IP addresses of your secondary security server, or press E
to accept the defaults that you set up earlier. If you are using local
security (i.e., RASExpress security rather than RADIUS or TACACs+),
leave these addresses set at the 0.0.0.0 default. When you press Enter, the
Getting RAS Express info menu reappears:
74. Change the Shared Secret Password by typing the Shared Secret option
number and ENTER.
2 Configuration Quick Start
:2
:Client_to_LAN
:0.0.0.0
Protocol:Local
(-(previous), q(uit), <1>):
to
NTER
NTER
63