Multitech CommPlete CC2400 System Installation And Quick Start Manual page 24

System Installation and Quick Start Guide
10. Connect one end of the provided E1 cable(s) to the E1 jack(s) on the
11. Turn on the RASCard. The indicator in the power switch and front panel
Installation of the CommPlete Communications Server hardware is complete. Your
next step is to configure the controller, RASCard, and E1 interface(s) so they can
communicate with the outside world. Please turn to Chapter 2.
24
RASCard, and the other end to an E1 wall jack.
Note: Do not connect the E1 line(s) until you are ready to perform the
configuration procedures.
should light.