Oil Pump Removal - Polaris 2014 Sportsman 570 EF Service Manual

ENGINE
3. Apply crankcase sealant to edges of rubber stator
grommet as shown below.
4. Set the stator in housing and press wire grommet
into slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of (3)
stator screws (C) and the (2) wire routing bracket
screws (D).
6. Install all (5) screws and torque to specification.
Stator to Cover Retaining Bolts (C):
9 ft-lbs (12 Nm)
Apply Loctite® 242™
Stator Wire routing Bolts (D):
6 ft-lbs (9 Nm)
Apply Loctite® 242™
7. Install a new stator cover gasket into the engine.
8. Install the stator cover as outlined in this chapter.
The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
3.72
CAUTION
result.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.

Oil Pump Removal

1. Remove the fasteners (1) retaining the intermediate
(mag) portion of the crank case and remove this
section of the crank case.
2. Rotate the crankshaft to TDC position by aligning the
timing hole(2) in crankcase with a timing hole in the
crankshaft. Insert a 1/4" drive socket extension
through the crankcase and into the crankshaft
locating hole.