Icom IC-V3500 Advanced Manual page 11

REPEATER OPERATION
2.
Accessing a repeater
Using the HM-133V
1 Set the receive frequency (repeater output frequency)
2 Set the frequency offset in the Set mode
3 Push [DUP- 7 TONE] or [DUP+ 8 TSQL
select the minus Duplex or the plus Duplex mode
• A "+" or "–" is displayed
4 Push [FUNC] then [DUP- 7 TONE] to turn ON
the subaudible tone encoder, depending on the
repeater requirements
• " " is displayed
L The 885 Hz tone frequency is set as the default
When a different tone frequency is needed to access
a repeater, see page 2-6 for setting the tone
frequency
5 Hold down [PTT] to transmit
• The displayed frequency is automatically changed to
the transmit frequency
• When "OFF" is displayed, confirm that the frequency
offset is correctly set (p 8-2)
6 Release [PTT] to receive
7 Push [MONI 1 ANM] to check whether or not
you can directly receive the signal from the other
station
L The transmit frequency is displayed
8 Push [SIMP 9 TSQL] to return to the Simplex
mode
• A "+" or "–" disappears
9 To turn OFF the subaudible tone encoder, push
[FUNC], and then [ENT C T-OFF]
D1750 Hz tone (Using the HM-133V)
A 1750 Hz tone is required to access many European
Repeaters
To send a 1750 Hz tone for 1 second
z Push [FUNC], and then [VOL▼
To continuously send a 1750 Hz tone
z Push [FUNC], and then hold down [VOL▲ 0 TONE-2].
L Release [VOL▲ 0 TONE-2] to stop the transmission.
] to
TONE-1]
2-3
Push or to select the
plus Duplex or the minus Duplex
mode
Push , and then
ON the subaudible tone encoder
Push return to the Simplex
mode
Push , and then
hold down 
to turn
or