Icom IC-V3500 Advanced Manual page 40

SCAN OPERATION
4.
Memory Bank scan
Using the HM-133V microphone
1� Push [MR/CALL] to select the Memory mode�
• " " and the Memory Channel number are displayed�
2� Push [BANK/OPTION] to select the Memory Bank
mode�
• " " and the bank letter blink�
L The bank name is displayed, if set�
3� Push [▲] or [▼] to select any bank.
L Banks that contain no Memory channels are skipped�
4� Push [CLR A MW] to exit the Memory Bank mode�
• " " and the bank letter are displayed�
5� Push [SCAN 2 T-SCAN] to start scanning�
• The frequency decimal point and "
L When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L Push [MONI 1 ANM] to stop or resume the scan�
6� Push [SCAN 2 T-SCAN] to cancel the scan�
TIP: You can also start scanning by holding down
[▲] or [▼] for 1 second.
Example: Starting a Bank scan in Bank A.
Push
MUTE
NAR
MID
LOW
LOCK
S ET
Push
MUTE
NAR
MID
LOW
" blink�
Push
MUTE
NAR
MID
LOW
Push
MUTE
NAR
MID
LOW
LOCK
S ET
Push
MUTE
NAR
MID
LOW
LOCK
S ET
4-9
to select the Memory mode�
DIGITAL PRIO AO BUSY
"
number are displayed�
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz
to enter the Memory Bank mode�
DIGITAL PRIO AO BUSY
"
or to select any bank� (Example: Bank A)
DIGITAL PRIO AO BUSY
to exit the Memory Bank mode�
DIGITAL PRIO AO BUSY
"
displayed�
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/ MHz
to start scanning�
DIGITAL PRIO AO BUSY
"�" and "
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz
" and the Memory Channel
" and the bank letter blink�
" and the bank letter are
" blink�