Icom IC-V3500 Advanced Manual page 19

MEMORY OPERATION
3�
Entering a Memory/Call channel
Using the HM-133V microphone
1� Set the frequency in the VFO mode.
L If desired, set other data (Example: frequency offset,
duplex direction, and tone squelch)�
2� Push [FUNC], and then push [CLR A MW].
• " " and the Memory channel number blink�
3� Push [▲] or [▼] to select a Memory or Call channel.
L If the selected Memory channel is blank, only the
Memory channel number is displayed�
4� Push [FUNC], and then hold down [CLR A MW] for
1 second to write�
• Three beeps sound�
L The Memory channel number automatically increases
when holding down [CLR A MW] after writing.
Example: Entering 145.870 MHz to Memory
channel 20.
Set the frequency in the VFO mode.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET TONE M/CALL
MONI LOW
Push
, and then
mode�
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Push
or to select Memory channel 20�
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Push
, and then hold down
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
3-5
PRIO SCAN
V/ MHz
to enter the Memory Write
" " and the Memory Channel
number blink�
PRIO SCAN
V/ MHz
PRIO SCAN
V/ MHz
for 1 second to write�
3 beeps sound�
PRIO SCAN
V/ MHz
PRIO SCAN
V/MHz