Icom IC-V3500 Advanced Manual page 64

TONE SQUELCH AND POCKET BEEP
7.
DTCS encoder (Transmit only)
The DTCS encoder superimposes the selected DTCS code over your transmitted signal
1 Repeatedly push [TONE T-SCAN] until both " "
and " " are displayed
• The DTCS encoder is activated
2 Push [SET LOCK] to enter the Set mode
3 Set the DTCS code and polarity
L See page 7-2 for details
L You can set the DTCS transmit and receive polarity,
but the DTCS encoder affects only transmit
4 Push any key other than [SET LOCK] or
[MONI ANM PA] to save and exit the Set mode
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET TONE
MONI LOW
" " and " " is displayed when the DTCS encoder is
activated
7-8
PRIO SCAN
M/CALL
V/MHz