Mitel MiVoice Business 3300 ICP Troubleshooting Manual page 48

Alarm
Document Version 1.0
Troubleshooting Guide
Probable Cause
RTC is set up with a
different virtual LAN
(vlan).
E2T card is defective.
Corrective Action
For 9.0 releases, on the Linux shell
enter: mcdDebug vlan_off Then log
into ESM, System Administration
Tool > Lan/WAN Configuration >
L2 Switch. On this form set VLAN ID
to 1. For 9.1 releases and onward,
on the Linux shell enter: mcdDebug
vlan_reset The E2T VLAN is reset
when the system is restarted. If the
E2T still fails to boot, on the Linux
shell enter: e2tCardConsoleStart
Log into the E2T card as root and
then set the VLAN to the proper value
by performing one of the following two
methods.If the E2T card cannot boot,
enter the following command in U-
boot: setenv vlan x saveenv If the
E2T card does boot, but cannot load
E2TLX, enter the following command
from the Linux shell: fw_setenv vlan
x.
Attempt to access the E2T serial
port using the following procedure
Determine Bootloader of the E2T card
in Technician's Manual. The default
baud rate should be 9600, but a card
may have a baud rate of 115200. If
nothing appears, then the E2T card
is either not seated correctly or is
defective.
Hardware
42