Table of Contents
Advertisement
3.2 Controllers
MXe III/MXe III-L Controller
Table 7: MXe III Controller Troubleshooting
Symptom
E2T fails to
initialize.
Document Version 1.0
Troubleshooting Guide
Probable
Corrective Action
Cause
Changing
For information and guidance for correcting this
from a hard
problem, refer to "Programming E2T via Debug Cable
coded E2T
or Secure Telnet" in the Technician's Handbook.
IP address
to requesting
one from the
DHCP server.
(If any IP
addresses
remain on the
E2T (at "inet
on ethernet",
"host inet",
or "gateway
inet"), the
E2T will use
them and
will obtain
the rest of its
parameters
from the
DHCP
server.)
RTC is set
From the RTC shell or the E2T VxWorks shell, remove
up with a
the vlan using the cv command.
different
virtual LAN
(vlan).
Hardware
46
Advertisement
Table of Contents
Troubleshooting
