Refresh Nas Share Names; Verify Nas And Das Performance; Delete A Nas - Christie IMB User Manual

3. Tap a NAS device in the NAS list.
4. Tap Test Performance.
5. Tap Change and select the test content.
6. Tap Start Test.
7. Tap Close.
8. Tap Cancel.

Refresh NAS Share Names

1. Tap Menu > Christie IMB > System.
2. Tap Storage.
3. Tap a NAS device in the NAS list.
4. Tap Refresh Share Names.
5. Tap OK.
6. Tap Save.
7. Tap OK.

Verify NAS and DAS Performance

To verify the performance of your NAS or DAS device, complete these tests:
• Ingest content. See
• Verify content plays without interruption. See
• Remove a hard drive from the NAS or DAS device and verify that playback is not interrupted.
• Test NAS performance. See
for the NAS device should be 500 Mbps. However, data transfer rates of 700 to 800 Mbps are
preferred. A KDM key is not required to test NAS performance.
• Measure NAS performance with a third-party application such as the
Toolkit (http://software.intel.com/en-us/articles/intel-nas-performance-toolkit/).

Delete a NAS

1. Tap Menu > Christie IMB > System.
2. Tap Storage.
3. Tap a NAS device in the NAS list.
4. Tap Delete.
5. Tap Yes.
Christie Integrated Media Block User Manual
020-100845-05 Rev. 1 (08-2013)
Ingest Content on page 48.
Test NAS Performance
Manage Storage Devices
Play Content on page 12.
on page 26. The minimum data transfer rate
Intel NAS Performance
27