Christie IMB User Manual page 18

Hardware Installation and Setup
6. Reach into the projector and press down on the lever on the right side of the card cage to release
the security ring.
7. Remove and discard the Christie IMB filler plate.
8. Unpack the Christie IMB and verify:
a. The holographic stickers covering the fasteners on the security enclosure are intact.
b. There are no obvious signs of tampering on the security enclosure.
c. The serial number stickers are in place and legible.
If the Christie IMB shows signs of tampering, contact Christie support. For contact information for
your region, see the back cover of this document.
9. Align the Christie IMB with the guides in the card cage, and then slide it into the projector until the
ejector tabs click to indicate they are locked.
10. Reassemble the projector:
a. Install the security ring.
b. Install the card cage cover.
c. Install and lock the high security cover.
d. Install and lock the top cover.
11. Connect the projector to AC power and then turn it on.
12. Tap Menu > Administrator Setup > Content Devices Configuration on the TPC.
13. Select Christie in the IMB Installed list.
If this is the first time you have installed an Christie IMB in the projector, the Christie IMB Plug-
in Updated - Reboot? dialog appears on the touch panel controller (TPC) within 2 minutes. Tap
Yes.
6 Christie Integrated Media Block User Manual
020-100845-05 Rev. 1 (08-2013)