Table of Contents
Advertisement
14
Utilities
To restore the oscilloscope to its default configuration
• Press the [Save/Recall] key, then press the Default Setup softkey.
The default configuration returns the oscilloscope to its default settings. This
places the oscilloscope in a known operating condition. The major default settings
are:
Horizontal
Vertical (Analog)
impedance, probe factor to 1.0 if an AutoProbe probe is not connected to the
channel.
Trigger
coupling, rising edge slope, 60 ns holdoff time.
Display
Other
Labels
preserved (not erased), but all channel labels will be set to their original names.
388
normal mode, 100 μs/div scale, 0 s delay, center time reference.
Channel 1 on, 5 V/div scale, DC coupling, 0 V position, 1 MΩ
Edge trigger, Auto sweep mode, 0 V level, channel 1 source, DC
Vectors on, 33% grid intensity, infinite persistence off.
Acquire mode normal, [Run/Stop] to Run, cursors and measurements off.
All custom labels that you have created in the Label Library are
Keysight InfiniiVision 6000L Series Oscilloscopes User's Guide
Advertisement
Table of Contents
