Ipsec Configuration - NetModule NB3710 User Manual

modifies the IP address/port of packets. It encapsulates packets in UDP and therefore
requires a slight overhead which has to be taken into account when running over small-
sized MTU interfaces.
Please note that running NAT-Traversal makes IKE using UDP port 4500 rather than
500 which has to be taken into account when setting up firewall rules.
Configuration
General
For setting up the tunnel you will have to configure the following parameters first:
Parameter
Remote peer
NB3710 User Manual 4.0
Figure 5.32.: IPsec Configuration
IPsec General Settings
IP address or host name of the remote IPsec peer. You may
specify 0.0.0.0 to act as a responder for roadwarrior clients.