Table of Contents
Advertisement
8.2.8 Motor self-tuning
Set PAR 2024 Autotune still to On to enable motor self-tuning.
The firmware will automatically reset it to Off.
The following warning messages are displayed at the start and end of Self-tuning:
Operations displayed on the optional keypad
When the self-tuning procedure is executed its progress is displayed. In this phase the first digit on the right indicates
the progress of the procedure by rotating the external segments of the display.
If an error occurs, the word Er is displayed with the error code. Press Prg to exit the error.
Note !
For further information see chapters "9.1 Asynchronous motor startup wizard" on page 81 and "9.2 Startup wizard for brushless motors on page 93 .
8.2.9 Asynchronous/Synchronous selection
•
To switch from Asynchronous to Synchronous:
Menu 4 - DRIVE CONFIG, PAR 6100 Load synch control
0 4
.88.
Enter
Press Enter to reset the drive and restart in the new operating mode.
Note !
Important: the default parameters including the LIFT application are reloaded.
This can only be done with the drive disabled.
•
To switch from Synchronous to Asynchronous:
Menu 4 - DRIVE CONFIG, PAR 6100 Load synch control
0 4
.88.
Enter
Press Enter to reset the drive and restart in the new operating mode.
Note !
Important: the default parameters including the LIFT application are reloaded.
This can only be done with the drive disabled.
8.2.10 Correspondence table displayed character/alphabet
A
B
C
1
2
3
Close Enable input
Open Enable input
85.50
.
6 1
. 00.
Enter
85.50
.
6 1
. 00.
Enter
D
E
F
G
H
I
4
5
6
7
8
9
ADL300 • Quick installation guide - Specifications and connection
Operations displayed on the integrated keypad
C EN
O EN
8
.
nt
E
Enter
8
.
nt
E
Enter
J
K
L
M N
O
P
0
Q
R
S
T
U
V W X
Y
Z
73
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
