Table of Contents
Advertisement
9.2 Startup wizard for brushless motors (with the optional keypad)
The ADL300 can operate with regulation modes: field-oriented vector control of permanent magnet synchronous mo-
tors (brushless).
Note!
Before starting, check the factory setting:
Menu 02 DRIVE INFO, parameter 02.2 Control type, PAR: 480, default=12.
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
05 LIFT
Menu 04 DRIVE CONFIG, parameter 04.2 Regulation mode, PAR: 552, default=Flux vector CL.
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
05 LIFT
The STARTUP WIZARD is a guided procedure used for quick start-up of the drive that helps to set the main
parameters.
It consists of a series of questions, relating to the various sequences for entering and calculating the parameters
necessary for correct drive and lift application operation. The order of these sequences is as follows:
●
Electrical connections
●
Setting motor parameters
●
Autotune with motor at stand-still or coupled to the load
●
Setting encoder parameters
●
Encoder phasing
●
Setting the maximum speed reference and maximum system speed
●
Setting system weights
●
Setting application parameters
Saving parameters
●
The format of the function selection page is as follows:
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
05 LIFT
Pressing the E key, the function to be programmed is accessed.
Press the ▼ (Down) key to move to the next function skipping the current function.
Press the ▲ (Up) key to return to the previous function.
To terminate the sequence of functions and return to the menu, press the ESC key.
The end of the start-up sequence is indicated with the page:
03 STARTUP WIZARD
End of se q uence!
Up=Back
Press the ▼(Down) key to exit the sequence and return to the menu.
100
02 DRIVE INFO
2/26
Control type
Synchronous
Value:
04 DRIVE CONFIG
2/19
x1
Regulation mode
Value: 2
03 STARTUP WIZARD
Set motor data?
E=Yes
Down=Exit
ADL300 • Quick installation guide - Specifications and connection
PAR:
480
12
PAR:
552
Flux vector CL
Down=Next
See step 1
See step 2
See step 3
See step 4
See step 5
See step 6
See step 7
See step 8
See step 9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
