HPE ProLiant DL160 Gen10 User Manual page 85
Hide thumbs
Also See for ProLiant DL160 Gen10:
- Maintenance and service manual (146 pages) ,
- Product end-of-life disassembly instructions (13 pages) ,
- Disassembly instructions manual (13 pages)
Table of Contents
Advertisement
•
M.2 SSD enablement option
•
M.2 SSD
•
T-10 Torx screwdriver
•
Phillips No. 1 screwdriver – required only if the M.2 SSD is not preinstalled on the enablement board.
If installing the M.2 SSD enablement board in slot 3, make sure that the processor 2 is installed.
Procedure
1.
Back up all server data.
2.
If installed, remove the front bezel.
3.
Power down the server.
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Disconnect all peripheral cables from the server.
6.
Do one of the following:
•
Extend the server from the rack.
Remove the server from the rack.
•
7.
Remove the access panel.
8.
Remove the primary PCI riser cage.
9.
Remove the expansion slot blank.
10. If installing the option into slot 2 or slot 3, do the following:
a. Remove the full-height bracket from the M.2 SSD enablement board.
Hardware options installation
85
Advertisement
Table of Contents
