HPE ProLiant DL160 Gen10 User Manual page 92
Hide thumbs
Also See for ProLiant DL160 Gen10:
- Maintenance and service manual (146 pages) ,
- Product end-of-life disassembly instructions (13 pages) ,
- Disassembly instructions manual (13 pages)
Table of Contents
Advertisement
4. Proceed to Preparing the server for operation on page 92.
Preparing the server for operation
Procedure
1. Install any options or cables previously removed to access the TPM connector.
2. Install the access panel.
3. Do one of the following:
a. Install the server in the rack, if necessary.
b. Install the server in the enclosure.
4. Power up the server.
a. Connect the power cords (rack and tower servers).
b. Press the Power On/Standby button.
Enabling the Trusted Platform Module
When enabling the Trusted Platform module, observe the following guidelines:
•
By default, the Trusted Platform Module is enabled as TPM 2.0 when the server is powered on after installing it.
•
In UEFI Boot Mode, the Trusted Platform Module can be configured to operate as TPM 2.0 or TPM 1.2.
•
In Legacy Boot Mode, the Trusted Platform Module configuration can be changed between TPM 1.2 and TPM 2.0, but
only TPM 1.2 operation is supported.
Enabling the Trusted Platform Module as TPM 2.0
92
Hardware options installation
Advertisement
Table of Contents
