HPE ProLiant DL160 Gen10 User Manual page 79

• Processor heatsink assembly option
• T-30 Torx screwdriver
Procedure
1. Identify the processor, heatsink, and socket module components.
2. Review the processor cautions.
3.
Back up all server data.
4. If installed, remove the front bezel.
5. Power down the server.
6.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7.
Disconnect all peripheral cables from the server.
8. Do one of the following:
Extend the server from the rack.
•
• Remove the server from the rack.
9. Remove the access panel.
10. Remove the dust cover from the processor socket you intend to upgrade.
11. Install the processor heatsink assembly:
a. Locate and align the Pin 1 indicator on the processor frame and the socket.
b. Align the processor heatsink assembly with the heatsink alignment posts and gently lower it down until it sits
evenly on the socket.
The heatsink alignment posts are keyed. The processor will only install one way.
A standard heatsink is shown, your heatsink might look different.
Hardware options installation 79