HPE ProLiant DL160 Gen10 User Manual page 38

2. (Optional) Install hardware options. For installation instructions, see Hardware options installation on page 46.
Rack the server
3. Install the server in a rack.
4. Decide how to manage the server:
• Locally: use a KVM switch or a connect a keyboard, monitor, and mouse.
• Remotely: connect to the iLO web interface and run a remote console:
a. Verify the following:
◦ iLO is licensed to use the remote console feature.
If iLO is not licensed, visit the HPE website:
http://www.hpe.com/info/ilo
◦ The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
◦ The iLO hostname is located on the serial pull tab.
◦ If a DHCP server assigns the IP address, the IP address appears on the boot screen.
◦ If a static IP address is assigned, use that IP address.
◦ The default login credentials are located on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
Power on the server
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
6. If Intel Xeon Gold 6244 Processors are installed, enable the enhanced cooling function.
Update the firmware
7. Using the SPP, update the following:
• System ROM
• Storage controller
• Network adapters
• Intelligent Provisioning
Set up storage
8.
Do one of the following:
• To configure the server to boot from a SAN, see the following guide:
38 Setup