Omron V530-R150E-2 Operation Manual page 95

STEP 2 Setting Reading Conditions
12
13
Press the TRIG Key on the Console to perform one reading.
Parameters are set based on the data obtained with this
reading. If reading is performed successfully, the teaching
function will automatically turn OFF. To repeat this opera-
tion, go back to SET mode and repeat the procedure from
step 7.
The parameters can be displayed and changed if necessary
from Reading Settings (Manual) .
Scn 0 MON
ABCDE12345
Color: B, Rev: OFF, Length: 167
The obtained parameters are displayed. These
parameters are registered as reading conditions.
In RUN mode, only the read data (ABCDE12345
in this example) is output to RS-232C.
This completes the settings.
Section
p.122
OK 229ms
Freeze (0)
5-3
83