Omron V530-R150E-2 Operation Manual page 91

STEP 2 Setting Reading Conditions
12
13
Press the TRIG Key on the Console to perform one reading.
Parameters are set based on the data obtained with this
reading. If reading is performed successfully, the teaching
function will automatically turn OFF. To repeat this opera-
tion, go back to SET mode and repeat the procedure from
step 7.
These parameters can be displayed and changed if neces-
sary from Reading Settings (Manual) .
Scn 0 MON
ABCDE12345
GrayEdgeVal: 64 (7~122), Rev: OFF
The parameters obtained are displayed. These
parameters are used as settings.
In RUN mode, only the read data (ABCDE12345
in this example) is output to RS-232C.
If reading is not performed correctly, the teaching function
will stay ON. To turn the teaching function OFF, select Read-
ing Settings (Manual) from the screen shown in step 8, and
press the ENT Key. The teaching function will be turned
OFF by entering the Reading Settings (Manual) window.
This completes the settings.
Section
p. 107
OK 6331ms
Freeze (0)
5-3
79