Omron V530-R150E-2 Operation Manual page 146

SET (Setting) Mode
Pixel Skipping Y
Note If Display Settings/Finder Pattern is set to ON, whether finder
patterns can be detected or not can be confirmed on the screen.
If detection is not possible, decrease the correlation threshold
value and the pixel sipping parameter and check the model
image.
If, on the other hand, too many places are detected, increase the
correlation value and pixel skipping parameter.
134
6
Change the pixel skipping parameters used to search for a
model. (1 to 20)
The processing time can be reduced if the pixel skipping pa-
rameters are set to larger values. However, depending on
the image, the search may not be performed since the accu-
racy is reduced. After changing the setting, perform a
search to confirm whether the search can be performed cor-
rectly.
Pixel Skipping X
7
Set the correlation threshold value for detecting finder pat-
terns.
Correlation values higher than the threshold are detected.
(1 to 100; Default setting: 55.)
Section
Set the number of pixels
skipped when searching.
6-1