Omron V530-R150E-2 Operation Manual page 37

Specifications
There are 3 kinds of COM OUT (*1 to *3) for each output terminal.
Connect with reference to the following table.
A
Top
Power supply o e su
+
–
Control output Co
RUN
BUSY
OK/NG Judgment output
COM OUT For RUN, ERR, BUSY,
(*1) GATE, and OK/NG
DSA Prohibited to use
COM IN
B
Top
Co c de ce ou u Coincidence output
DO 1
DO 3
Prohibited to use o b ed o use
DO 5
DO 7
NC Not connected
Prohibited to use o b ed o use
DO 9
DO 11
DO 13
DO 15
Note
24
y
o ou u
1. Do not reverse the connections of the signal terminals and
COM terminals.
2. Do not use RESET input immediately after power is turned
ON.
When using RESET input to synchronize execution timing,
wait at least 1 s after turning ON the V530-R150 power sup-
ply before turning ON the RESET terminal.
Bottom
NC Not connected
Appropriate ground
ERR Error output
GATE Control output
NC Not connected
RESET Restart
TRIG A Trigger input (One shot
mode)
TRIG B Trigger input (Continuous or
Level Trigger mode)
Bottom
Co c de ce ou u Coincidence output
DO 0
DO 2
Prohibited to use o b ed o use
DO 4
DO 6
COM OUT For DO 0 to DO7
(*2)
Prohibited to use o b ed o use
DO 8
DO 10
DO 12
DO 14
COM OUT For DO 8 to DO15
(*3)
Section 3-1