Omron V530-R150E-2 Operation Manual page 133

SET (Setting) Mode
Note If the teaching operation is not successful, measure the length of
finder pattern using Image Analysis/Measure Length and set
this value for length of the finder pattern in Reading Settings
(Manual) , and then repeat the teaching operation.
6
Press the TRIG Key on the Console to perform one reading.
Parameters will be set based on the results of this reading. If
the reading is performed correctly, the teaching function will
automatically turn OFF. To redo the settings, go to SET
mode and repeat the procedure from step 1.
It is possible to view and, if necessary, change the parame-
ter setting in Reading Settings (Manual) .
ABCDE12345
Color: B, Rev: OFF, Length: 179
The parameters obtained are displayed. These
parameters are registered as settings.
In RUN mode, only the read data (ABCDE12345
in this example) is output to RS-232C.
If reading is not performed correctly, the teaching function
will stay ON. To turn the teaching function OFF, select Read-
ing Settings (Manual) from the screen shown in step 2, and
press the ENT Key. The teaching function will be turned
OFF by entering the Reading Settings (Manual) window.
Section
p.122
OK 714ms
Freeze (0)
121
6-1