Toe-In Of The Front Driving Axle Wheels - Zetor 86 41 forterra turbo Operator's Manual

TOE-IN OF THE FRONT DRIVING AXLE WHEELS

- Turn wheels parallel with longitudinal tractor axis.
- Measure the distance between rims in front in the horizontal wheel axis plain. Mark
the measuring points.
- Drive the tractor so that the marked points will be in rear horizontal position (turned
by 180°) and again measure the distance between marked points
- Loosen locknuts (2) on ball joints onboth ends of the steering cylinder piston rod.
- Turn the ball joints (3)as necessary to obtain proper toe - in (ball joints have swiwel
mount in the cylinder piston rod so they will turn). Turn both ball joints by the same
amount so tie rods (1) will have approximately same lenght.
- Tighten locknuts (2) on both tie rods
CHANGING THE WHEEL TRACK
150
F_02_160