Mounting Cutout Housing R; Figure 9: Mounting Cutout For Combivert P6 Housing R (Provided By Customer) - KEB COMBIVERT P6 Instructions For Use Manual

Installation p6 pitch inverter 18/19/23p6 housing g, r

Hide thumbs Also See for COMBIVERT P6:

Table of Contents

DIMENSIONS AND WEIGHTS

3.4.4 Mounting cutout housing R

Figure 9:

Mounting cutout for COMBIVERT P6 housing R (provided by customer)

NOTICE





NOTICE

Ensure correct material thickness !

The material thickness of the cabinet back wall and the mounting meth-

od must be chosen that way the material does not bend. Together with

the rubber seal of the P6, protection class IP54 is maintained. If the ma-

terial thickness exceeds 8 mm (18 / 19P6) or 14 mm (23P6), the P6 must

be removed from the cabinet prior to replacing the heatsink fan.

Observe fan direction !

The installation of the drive controller in the control cabinet and its in-

stallation in the wind turbine must be carried out such that the fan axis

of the drive controller is parallel to the rotational axis of the hub of the

wind turbine.

Table of Contents