Table of Contents
Advertisement
Password Prompt
]
The
Password prompt requires an administrator or user password followed by a carriage
return. The prompt is repeated if the incorrect password is entered.
If the correct password is entered, the unit responds with
]
Login User
administrator and user, the unit will default to administrator privileges.
NOTES:
•
The factory configured password for this device is set to the device serial number.
When performing a factory reset, the password is set to the default password,
which is no password.
•
Passwords are case sensitive. Passwords only apply to IP connections and can be
up to 128 characters in length.
Using the Command and Response Table
Symbols are used throughout the SIS tables to represent variables in the command
response fields. Command and response examples are shown throughout the table. The
ASCII to HEX conversion table (see figure 40) is for use with the command and response
tables.
ASCII to Hex Conversion Table
Space
Figure 40.
NOTE: For commands and examples of computer or device responses used in this
guide, the character "0" is the number zero and "O" is the capital letter "o".
Error Responses
When the DMP 64 Plus is unable to execute the command, it returns an error response to
the host. The error response codes and their descriptions are as follows:
E10 – Unrecognized command
E12 – Invalid port number
E13 – Invalid parameter
E14 – Not valid for this configuration
E17 – Invalid command for signal type
E18 – System timed out
E22 – Busy
]
depending on the password entered. If passwords are the same for both
ASCII to Hex Conversion Table
]
Login Administrator
•
E24 – Privilege violation
E25 – Device not present
E26 – Maximum connections exceeded
E27 – Bad filename or file not found
E28 – Bad file name or file not found
E31 – Attempt to break port pass-through
when not set
DMP 64 Plus• SIS Configuration and Control
]
or
37
Advertisement
Table of Contents
Troubleshooting
