Installation; Installation Overview; Rear Panel Features - Extron electronics DMP 64 Plus User Manual

Installation

This section describes the installation of the DMP 64 Plus, including:
•
•
•
•
•

Installation Overview

Follow these steps to install and set up the DMP 64 Plus for operation:
1.
2.
3.
4.

Rear Panel Features

A
B
C
D
Figure 2.
A
B
Installation Overview
Rear Panel Features
Front Panel Features
Connection Details
Reset Modes
Disconnect power from the DMP, and turn off all devices connected to the DMP.
If desired, mount the DMP (see
Connect the cables, and configure the DMP (see "Rear Panel Features" starting below).
Plug in the power supply and all connected devices.
I
1 2 3 4
POWER
12V
2.0A MAX
1 (PRI) PoE+
A B
Power input
EXP port
AT ports (AT models only)
ACP port
Rear Panel Features
Power input — Connect the included external 12 V, 2.0 A power supply to the 2-pole
captive screw inlet (see Power Supply Wiring
EXP port — Connect an EXP-enabled device to this RJ-45 port for a digital audio
connection using Extron proprietary protocol.
NOTE: A one foot shielded CAT 6 cable is provided for the EXP connection. The
maximum EXP cable length supported is 33 feet (10 meters).
Equipment Mounting
J
5 6 1 2 3 4
IN G O IN G O IN G O IN G O
RS-232
2 (SEC) +V +S -S G Tx Rx G
C D E
RS-232 port
E
LAN ports
F
USB-Audio port
G
Reset button and LED
H
on page 9 for wiring details).
on page 90).
K
5 6 1 2 3 4
IN G O IN G O
USB AUD
R
1 2 C V AT
F G
Mic/Line inputs
I
Digital I/O ports
J
Line outputs
K
DMP 64 Plus • Installation
H
4