Finding A Dante Device Ip Address - Extron electronics DMP 64 Plus User Manual

To rename a DMP 64 Plus receiver or transmitter:
Figure 31.
1. Open the Device View dialog box of the DMP 64 Plus.
2. From the (Select a Dante Device..) drop-down list, select the name of the
desired DMP 64 Plus (see figure 31,
On the Device View screen, select the Receive tab or Transmit tab (
3.
4. Click the name of the receiver or transmitter to be renamed. The name becomes a text
box with a cursor (
5. Enter the new name (up to 31 characters) using any combination of letters, numbers,
and special characters except for @, =, and . (period).
6. Press <Enter> on the keyboard to confirm the name, or click another channel text box.
7. Repeat steps 4 through 6 to rename additional receiver or transmitter channels.
8. When finished renaming receivers and transmitter, close the Device View dialog box.

Finding a Dante Device IP Address

To find the IP address of a Dante device, the name of the device is needed (see
the DMP 64 Plus in Dante Controller
NOTE: If the DMP 64 Plus has not been renamed, its default name consists of the
product name followed by a hyphen, plus the last 6 digits of the device MAC address
(for example, DMP64Plus-0ee8ee).
Figure 32.
1. Open Dante Controller.
On the Dante Controller-Network View screen, click the Device Info tab (see
2.
figure 32,
On the Device Info page, locate the name of the DMP 64 Plus in the
3.
column (
figure 32, the IP address for the connected DMP 64 Plus is 192.168.11.120.
Device View Screen — Renaming a Receiver or Transmitter
).
3
Device Info Page
).
1
). The IP address is located in the Primary Address column (
2
).
1
on page 23).
DMP 64 Plus • Dante Controller
) as desired.
2
Renaming
Device Name
). In
3
26