Verbose Modes; Simple Instruction Set Control; Host-To-Unit Instructions; Device-Initiated Power-Up Message - Extron electronics DMP 64 Plus User Manual

Verbose Modes

Telnet connections can be used to monitor for changes that occur, such as SIS commands
from other Telnet sockets or serial port changes. For a Telnet session to receive change
notices, the Telnet session must be in verbose mode 1 or 3. In verbose mode 1 or 3, the
Telnet socket reports changes in messages that resemble SIS command responses (see
Set verbose mode
Tagged and Untagged Responses
When a query command is sent in verbose mode 0 or 1, only the "untagged" value is
returned. When a query command is sent in other verbose modes, the response is "tagged"
and resembles the response to a set command.
Examle: The gain query command
appear depending on the verbose mode:
•
•
NOTE: All query responses listed in this guide are shown untagged.

Simple Instruction Set Control

Host-to-Unit Instructions

SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command character sequence. When a command is valid, the
transmitter executes the command and sends a response to the host device. All responses
from the transmitter to the host end with a carriage return and a line feed (CR/LF = ]] ),
which signals the end of the response character string. A string is one or more characters.

Device-Initiated Power-Up Message

When the device completes its start-up, it issues the following message to the host:
© Copyright 2019-2022, Extron Electronics DMP 64 Plus {model}
60-nnnn-nn
Day, DD MMM YYYY HH:MM:SS
•
•
•
The DMP 64 Plus sends the boot and copyright messages under the following
circumstances:
•
•
on page 46).
Untagged (verbose 0 or 1): 626
Tagged (verbose 2 or 3): DsG40000*626
and the gain value.
]
]
{model} is the full model name (for example, DMP 64 Plus C V AT).
Vx.xx is the firmware version number
60-nnnn-nn is the part number of the unit
If the DMP 64 Plus is off and RS-232 connection is already set up (the PC is cabled to
the DMP 64 Plus and a serial communication program such as DataViewer is open), the
connected unit sends these messages via RS-232 when first powered on.
The DMP 64 Plus sends the boot and copyright messages when a Telnet connection to
the DMP 64 Plus is opened via Telnet, but not via RS-232. If using a Telnet connection,
the copyright message, date, and time may be followed by a password prompt.
E }
G40000AU
is sent. The following responses
]
, just the gain value with no other information.
]
, the type of query sent, the OID queried,
DMP 64 Plus• SIS Configuration and Control
Vx.xx
, ,
36